GET THE APP

Diamond-like carbon thin film deposition by filtered cathodic vacuum arc source for wear resistance improvement of zirconia toughened alumina
..

Journal of Material Sciences & Engineering

ISSN: 2169-0022

Open Access

Diamond-like carbon thin film deposition by filtered cathodic vacuum arc source for wear resistance improvement of zirconia toughened alumina


8th International Conference and Exhibition on Materials Science and Engineering

May 29-31, 2017 Osaka, Japan

Ju Hyeon Choi

Korea Photonic Technology and Institute, Republic of Korea

Scientific Tracks Abstracts: J Material Sci Eng

Abstract :

Alumina has been used as engineering ceramic material widely due to high mechanical strength and hardness, wear and corrosion resistance. For higher strength and toughness, Zirconia Toughened Alumina (ZTA)which has zirconia grains in alumina matrix has been used. However, ZTAhas lower hardness and wear resistance than alumina. To improve the wear resistance of engineering ceramic, hard coating like Diamond-Like Carbon (DLC) coating on ceramicsurface has been used.In this study, tetrahedral amorphous carbon (ta-C) film which is the hardest DLC was deposited on ZTA by using Filtered Cathodic Vacuum Arc (FCVA) source and the wear resistance, hardness and scratch resistance was investigated according to the substrate bias conditions.The pulse bias was used for the substrate bias and the pulse frequency was 16 kHz and the rise time of the pulse was about 1 ├?┬╝s. Because it was known that the hardness of ta-C thin filmis related with the residual stress, the residual stress of the ta-C thin film deposited on dielectric material by FCVA source was investigated with various pulse voltages. The residual stress of ta-C thin film decreased monotonically with the substrate pulse bias. To obtain both high wear resistance and low residual stress, a bi-layer deposited with both high pulse voltage and low pulse voltage was deposited on ZTA. Through the pin-on-disk tests, the wear resistance was investigated in various thickness conditions of the ta-C bi-layer. It was found that the high residual stress layer has higher wear resistance. By using nano-scratch tester,it was found that the low residual stress layer has higher scratch resistance. The hardness and elastic modulus of ta-C thin film on ZTA was measured by usingunltranano-indenter.

Biography :

JuHyeon Choi received the B.S., M.S. in Materials Science from Chonnam National University. He received Ph.D. degrees in Materials Science from University of California Irvine, USA, in 2004. His major research topics was photonic laser glass for fiber laser and fibe amplifiers. From 2005 to 2009, he joined Surface Science Lab at UCI and was engaged in development of metal nanoparticle arrays for plasmonic field enhanced bio sensor. He joined Dr. Jane Chang’s group as a staff scientist at UCLA from 2010, where he has been engaged in research on nano phosphors with core-shell nanostructure, multifunctional oxide thin film by atomic layer deposition method. He is now a senior researcher working in the field of optical materials, DLC thin film deposition for ceramic material, especially infrared optical glass in Korea Photonic Technology and Institute, Korea.

Email: juchoi2@kopti.re.kr

Google Scholar citation report
Citations: 3210

Journal of Material Sciences & Engineering received 3210 citations as per Google Scholar report

Journal of Material Sciences & Engineering peer review process verified at publons

Indexed In

 
arrow_upward arrow_upward